Repairs have already begun, and the project is not ready for power? What to do? Hire professionals, pay them $ 1000 and a draft power, which they copied from their base they do not, incidentally, worked out? Tell them no. In today's environment where there is access to information when the (more recently) for the design of power supply does not require a license and basic technical education have virtually all Design of power supply in your house or apartment under the force and yourself. Wiring and electrical design in the ongoing repair – normal types of problems for Russia. (Not to be confused with Mashable!). Well, get down. Andy Florance contains valuable tech resources. The first thing to start – this plan.
The project runs on electricity finished layout. If the ground under the power project is not ready, then you should prepare. Take the checkered paper, a ruler, choose the scale and go into a furniture store in the directory from which we take the size of furniture, we cut them out of the cells and papers will be moving around the room. Do not forget also the doors and windows. The project takes into account supply and typically natural light – a table for reading, working with a computer or child's room should be well lighted by natural light.
Remember this is taken into account when designing the arrangement of furniture and supplies. When ready planning, start the alignment sockets, lamps and chandeliers – this is the main part of the project supply. Just plan it where there will be ramifications of wiring, and lay there raspayachnye box. To supply Outlets are usually used wire 2.5 mm2, and for lighting 1 or 1.5 mm2. Show on plan the location of the electrical panel. Consider it a separate machine outlets and lighting, as well as the opening gun for a full consumable you power. Continue to have a bill of materials – is the final stage of designing supplies. Project power, we have finished now begin the installation. According to the project electricity paving within the walls of group lines in Stroebe. Cut in the wall of the deepening of a switch and . If the project provides electricity bill electrical panel, then under it do not have to knock out hole in the wall. If same board recessed, then recess to be done in the form of built-in wall of the electrical panel. When purchasing materials to conduct electrical installations according to your project, electricity, pay attention to quality. This work is done once and for all, so do not skimp on it. With good materials easier and more convenient to work with.